KAYO S200

Throttle Cable For Nibbi Carburetor . (This cable is about 8” shorter than the OEM. It will work if you reroute the cable over the oil cooler. You will have to drill out the cable end where it bolts up for the pedal to a 7/16” hole size.)

Custom made front bumper replacement. Made from 3/16 steel plate. Has winch mount.

More picture coming soon!

Battery Tray (relocation). Designed for larger battery (U1 lawn mower battery) Welding required. Battery cables not included.

More images coming soon!

Clutch cover bearing (for secondary clutch support bearing)

Ball Joint (upper or lower) comes with castle nut and snap ring.

Nibbi PE28 carburetor (comes with carburetor, gasket set, jets, air filter, fuel filter/hose,nut and bolt kit)

Engine Reverse Shaft Main

OEM style Clutch (comes with primary and secondary clutches and belt)

Cam Shaft (with cam bearings) Stock unit.

Air Filter (OEM style)

Starter Clutch

Forward and Reverse Gear Set

Transmission Output Gear

Timing Chain Set (comes with top and bottom guides, chain, chain tensioner)

Cylinder Head (does NOT come with a head gasket)

Cylinder Jug and Piston. (comes with jug, piston, wrist pin, wrist pin clips, piston rings, jug gasket, head gasket)

Piston Pin Puller (comes with 11,13,16,19,22MM size bushings)

Rear Axle CV Boots (for inner or outer boot, will need to trim to fit) comes with clamps and zip ties

Rear Brake Lines along rear arms 24” long (will work for left or right side) comes with banjo bolts and washers.

Rear Brake Pads (comes with 2 pads as a set)

Steering Rack Boots (comes as a pair) comes with clamps and zip ties (THIS IS A CUT TO FIT BOOT)

Tie Rod End (left hand thread) comes with jam nut, castle nut, dust boot. (WORK FOR LEFT OR RIGHT SIDE OUTER TIE ROD END)